| Nominal Frequency | 40.000000 | MHz | |
| Mode of Oscillation | Fundamental | | |
| Frequency Tolerance | 10 | ppm | at 253 |
| Equivalent Resistance (RR) | 80 | | SERIES |
| Storage Temperature Range | -40 to +85 | | |
| Operable Temperature Range | -30 to +85 | | |
| Temperature Stability | 10 | ppm | -30~ +85 |
| Loading Capacitance (CL) | 9.0 | pF | |
| Drive Level (DL) | 10 to 100 | W | |
| Shunt Capacitance (C0) | 2.0 | pF | |
| Insulation Resistance | 500 | M | at DC 100V |
| Aging | 3 | ppm/Year | |
| Circuit Measurement | | | Measured in HP/E5100A, S&A 250B |
| Dimensions (L x W) | 1.6 x 1.2 | mm | (Refer to Dimension Diagram) |
| Pin Connections | #1 Crystal, #2 Crystal, #3 GND/Lid, #4 GND/Lid | | |
| Carrier Tape Width | 8.0 | mm | 0.2 |
| Reel Quantity | 3000 | PCS/REEL | Standard Packing Quantity |
| Shock Test | Dropping from 120 cm height 3 times on 30 mm Concrete floor. | | Refer to: JIS C 60068232 A |
| Vibration Test | Frequency 1055Hz, Sine Wave full amplitude of 0.8mm to X, Y and Z 3 axes, 2 cycles and duration of 2 hours to each direction. | | Refer to: JIS C 6006826 A |
| Leakage Test | 1.0x109 | Pam/sec. Max. | Measured by Helium leak detector. |
| Solder Ability Test | Dipping in solder bath at 245deg.C 5deg.C for 3 0.5 sec. | | Refer to: JIS C 60068220 B |
| Bending Strength Test | Board bent to 3 mm and hold for 5 1 sec. Pressure speed: 0.5 mm/sec. | | Refer to: EIAJ ET7403 A |
| Adhesion Test | Pressure: 5N for 101 sec. | | Refer to: EIAJ ET7403 C |
| Body Strength Test | Pressure: 5N for 101sec | | Refer to: EIAJ ET7403 C |
| Resistance of Soldering Heat | Specification A | | FREQ. DRIFT: 5 ppm Max, RESISTANCE DRIFT: 15% or 2 |
| Humidity Test | 602, RH 90~95%, duration of 240 hours. | | Refer to: JIS C 6006823 A |
| Storage in Low Temperature | -40deg.C 2deg.C, duration of 240 hours. | | Refer to: JIS C 6006821 A |
| Storage in High Temperature | +85deg.C 2deg.C, duration of 240 hours. | | Refer to: JIS C 6006822 A |
| Temperature Cycles | -40deg.C 2deg.C (30min) +85deg.C 2deg.C (30min) 25 cycles. | | Refer to: JIS C 0025 A |
