| General - Holder Type | HC-49USSMD | | |
| General - Mode of Vibration | AT CUT | | FUND |
| General - Oscillation Mode | S&A | | |
| General - Test Facilities | KH-1240 | | |
| General - Storage Temperature | -40 to +85 | | |
| General - Driver Level | 100 | W | |
| Electrical Parameter - Normal Frequency | 8.000 | MHz | |
| Electrical Parameter - Frequency Tolerance (252) | 30 | ppm | |
| Electrical Parameter - Temperature Stability | 20 | ppm | |
| Electrical Parameter - Operating Temperature Range | -20 to +70 | | |
| Electrical Parameter - Load Capacitance | 20 | PF | |
| Electrical Parameter - Motional Capacitance | 3 | PF MAX | |
| Electrical Parameter - Shunt Capacitance | | | Not Specified |
| Electrical Parameter - Effective Series Resistance | 250 | MAX | |
| Electrical Parameter - Insulation Resistance | 500 | M OHMS MIN | AT DC 100V |
| Mechanical Parameter - Solderability | 95% Coverage | | BY USING 90/10 SOLD AT 245 FOR 5 SEC. DIPING AFTER IMMERSION IN ALPHA 611 FLUX FOR 5 SEC. |
| Mechanical Endurance - Shock | Satisfied | | Electrical characteristics shall be satisfied after dropping three times from the height of 50 cm onto Hard wooden board. |
| Mechanical Endurance - Vibration Frequency | 1055 | Hz | |
| Mechanical Endurance - Vibration Period | 12 | min | |
| Mechanical Endurance - Vibration Full Amplitude | 1.5 | mm P-P | |
| Mechanical Endurance - Vibration Direction | X.Y.Z | | |
| Mechanical Endurance - Vibration Time | 2 | hours/each direction | |
| Mechanical Endurance - Strength of Terminals/Lead-Wires - Pulling | 900g | | Tension weight for 30 sec. No visual damages. |
| Mechanical Endurance - Strength of Terminals/Lead-Wires - Bending | 225g | | 90degree bending. No visual damages. |
| Mechanical Endurance - Sealing Tightness | No bubble | | After specimen put in hot water at +90+95 for 5 min. |
| Mechanical Endurance - Soldering Dip | >90% | | Terminals/lead-wires dipped into solder at +2305 for 3sec. Dipping depth 2mm. |
| Mechanical Endurance - Solder Heating | Satisfied | | Terminals/lead-wires dipped into solder at +35010 for 3 sec. Electrical characteristics shall be satisfied. |
| Environmental Endurance - Humidity | Satisfied | | After 250 hours at 602, 90-95% humidity. Electrical characteristics shall be satisfied. |
| Environmental Endurance - Storage in Low Temperature | Satisfied | | After 250 hours at -302. Electrical characteristics shall be satisfied. |
| Environmental Endurance - Storage in High Temperature | Satisfied | | After 250 hours at +852. Electrical characteristics shall be satisfied. |
| Environmental Endurance - Temperature Cycle | Satisfied | | 3 cycles. Temperature shift 1/min. Electrical characteristics shall be satisfied. |
