Home > Ceramic Filters >

Frequency filtering SMD dielectric ceramic Monoblock filter ECS ECS-DCF-108 with RoHS directive compliance

Product Categories

Crystals [3000]
Delay Lines [5]
Aluminum - Polymer Capacitors [1170]
Aluminum Electrolytic Capacitors [3000]
Oscillators [539]
Thumbwheel Potentiometers [25]
Chassis Mount Resistors [135]
Chip Resistor - Surface Mount [2074]
Capacitor Kits [6]
Resistor Kits [17]
Cable Ferrites [84]
Common Mode Chokes [1585]
Arrays, Signal Transformers [34]
Value Display Potentiometers [4]
Ferrite Beads and Chips [1587]
Wireless Charging Coils [34]
Current Sense Resistors [126]
Power Line Filter Modules [49]
Capacitor Networks, Arrays [24]
Electric Double Layer Capacitors (EDLC), Supercapacitors [3]
EMI/RFI Filters (LC, RC Networks) [154]
Ceramic Capacitors [3000]
Film Capacitors [843]
Resistor Networks, Arrays [637]
Pin Configurable/Selectable Oscillators [13]
Stand Alone Programmers [1]
Fixed Inductors [3000]
Silicon Capacitors [2]
Ceramic Filters [216]
Adjustable Power Resistor [64]
Rotary Potentiometers, Rheostats [235]
Trimmer Potentiometers [1622]
Specialized Resistors [144]
VCOs (Voltage Controlled Oscillators) [81]
Through Hole Resistors [711]
Resonators [79]
Ferrite Cores [96]
Feed Through Capacitors [134]
Slide Potentiometers [123]
Tantalum - Polymer Capacitors [175]
Tantalum Capacitors [143]
RF Filters [231]
Motor Start, Motor Run Capacitors (AC) [29]
Thin Film Capacitors [999]
Programmable Oscillators [242]
Trimmers, Variable Capacitors [10]
SAW Filters [201]

Beijing Silk Road Enterprise Management Services Co., Ltd.

Trust Seal

Verified Supplier

Credit Check

Supplier Assessment

Contact Now

Frequency filtering SMD dielectric ceramic Monoblock filter ECS ECS-DCF-108 with RoHS directive compliance

Frequency - Center : 6.525GHz

Description : 6.525GHz Ceramic Filters RoHS

Mfr. Part # : ECS-DCF-108

Model Number : ECS-DCF-108

Contact Now

Product Overview

This specification covers the characteristics of the ECS-DCF-108 dielectric ceramic filter. It is a SMD dielectric ceramic Monoblock construction and conforms to the RoHS directive and national environment protection law. This filter is designed for applications requiring specific frequency filtering capabilities.

Product Attributes

Brand: ECS Inc. International
Part Number: ECS-DCF-108
Construction: SMD dielectric ceramic Monoblock
Certifications: RoHS directive, national environment protection law

Technical Specifications

Item	Requirement
Withstand DC Voltage	50V (1min max)
Insulation Resistance	M min. 10010V1min5s
Storage temperature	-40 85
Operation Temperature Range	-40 85C
Center frequency	6525.0 MHz
Bandwidth [BW]	5925-7125 MHz
Insertion Loss in BW	max 3.5@5925-5945@25, 3.0@5945-7125@25, 4.0@5925-5945@-4085, 3.5@5945-7125@-4085
Ripple in BW	max 3.0 dB
Return Loss in BW	min 9.0 dB
Attenuation[Absolute Value]	min 45.0 @ 5640-5835 MHz, 50.0 @ 0-5640 MHz
Input Power	max. 1 W
In/Out Impedance	50 ohm

Environmental Tests

No.	Item	Test Condition	Remark
5.1	Humidity Test	90%~95% relative humidity 402 for 96h~98h, then dry out at 255 and less than 65% relative humidity for 2h~4h.	After drying out the device shall satisfy the specification in table 1.
5.2	High Temperature Exposure	85 for 16h, measured after 2h~4h at 255 and less than 65% relative humidity.	It shall fulfill the specifications in Table 1.
5.3	Low Temperature	-40 for 16h, measured after 2h~4h at 255 and less than 65% relative humidity.	It shall fulfill the specifications in Table 1.
5.4	Temperature Cycle	-25 for 30 min. followed by 85 for 30 min, repeated 5 times. Room temperature for 1h~4h prior to measurement.	It shall fulfill the specifications in Table 1.
5.5	Vibration	2h each in x, y, and z axis with amplitude of 1.5mm, frequency varied between 10Hz~55Hz.	It shall fulfill the specifications in Table 1.
5.6	Soldering Test	Preheating at 120~150 for 60 seconds and dipping in soldering Sn at 2605 for 101 seconds.	Mechanical damage shall not occur.
5.7	Solder Ability	Dipped in 2605 solder bath for 3s0.5 s with rosin flux (25wt% ethanol solution.)	The terminals shall be at least 95% covered by solder.
5.8	Terminal Pressure Strength	Subjected to be soldered on test PCB. Apply 5N of force for 10s1s in the direction of the arrow.	Mechanical damage such as breaks shall not occur.

Characteristics After Environmental Tests (Table 1)

Item	Characteristics after test
Insertion Loss Change	dB max 0.3
Ripple Change	dB max 0.3
Return loss.	dB max 2.0
Attenuation Change	dB max 4.0

Recommended Soldering Conditions

Phase	Profile features	Pb-Free Assembly
PREHEAT	-Temperature Min -Temperature Max -Time	150 200 60-120 seconds
RAMP-UP	Avg. Ramp-up Rate (200 to 260)	3/second(max)
REFLOW	-Temperature -Total Time above 220	220 30-100 seconds
PEAK	-Temperature -Time	260 3-5 seconds
RAMP-DOWN Rate	2-6/second
Time from 25 to Peak Temperature	8 minutes max
Composition of solder paste	Ag3.0/Cu0.5/ Sn

Other

Caution

Dont apply excess mechanical stress to the component and terminals at soldering. Do not use this product with bend.
Do not clean or wash the component for it is not hermetically sealed.
Do not use strong acidity flux, more than 0.2wt% chlorine content, in flow soldering.
This specification mentions the quality of the component as a single unit. Please ensure the component is thoroughly evaluated in your application circuit.
Expire date (Shelf life) of the products is six months after delivery under the conditions of a sealed and an unopened package. Please use the products within six months after delivery. If you store the products for a long time (more than six months), use carefully because the products may be degraded in the solderability or rusty. Please confirm solderability and characteristics for the products regularly.
Please contact us before using the product as automobile electronic component.

Notice

Please return one of these specifications after your signature of acceptance.

2412061726_ECS-ECS-DCF-108_C6844216.pdf

Frequency filtering SMD dielectric ceramic Monoblock filter ECS ECS-DCF-108 with RoHS directive compliance Images

Inquiry Cart 0

Send your message to this supplier


*From:	Your email address is incorrect!
*To:	Beijing Silk Road Enterprise Management Services Co., Ltd.
*Subject:	Subject is empty!
*Message:	For the best results, we recommend including the following details: -Self introduction -Required specifications -Inquire about price/MOQ Characters Remaining: (0/3000) Please enter 20 to 3000 characters to contact this supplier!