| Rated voltage | 16 V | |
| Rated capacitance | 220~560 F | 20, 120Hz |
| Tolerance on rated capacitance | 20 % | |
| Surge voltage | UR 1.15 | |
| Leakage current | See specifications list | 20, After 2 minutes; Series resistor: 1,000 ; Applied rated voltage 2 minutes. Voltage treatment: applied for 2h at 105 2, then stored for 12 h to 24 h. |
| Tangent of loss angle (tan) | See specifications list | 202 |
| Equivalent Series Resistance (ESR) | See specifications list | 100 kHz10%; Measuring voltage: 0.5Vrms, Measuring temperature: 202 |
| Rated ripple current | See specifications list | 105, 100 kHz |
| Category temperature range | -55 to 105 | |
| Lifespan | 105 , 2000 h | |
| Solderability | At least 95% of circumferential surface covered with new solder. | Flux: Rosin // Ethanol, About 25 wt% Sn-Ag-Cu solder; Temperature: 2453, Duration: 20.3 seconds |
| Robustness of terminations (Tensile) | See table | Gradual force application up to specified value. |
| Robustness of terminations (Bending) | See table | Bend through 90 and return to original position, 2-3 seconds per cycle. |
| Resistance to soldering heat | Capacitance: Within 5% of initial value; tan: Within the value of item 2; Leakage current: Within the value of item 2. | Solder bath method: Temp: 2605C, Duration: 10 1 seconds. Soldering iron method: Temp: 40010C, Duration: 3+1/0 seconds. |
| Vibration | Capacitance: No drastic change compared to initial value; Capacitance change: Within 5% of initial value. | Frequency: 10 to 55 Hz (1 min interval); Amplitude: 0.75 mm; Direction: X, Y, Z (3 axes); Duration: 2 hours/axial. |
| Rapid change of temperature | Capacitance change: Within 10% of initial value; tan: Within the value of item 2; Leakage current: Within the value of item 2. | Cycle number: 5 cycles. Applied voltage: Without load. TA= -55 TB= 105 . |
| Shelf Life | Capacitance change: Within 20% of initial value; tan: Within 2 times of item 2 value; Leakage current: Within item 2 value. | Temp: 105 2; Time: 1000+36 hours. Voltage treatment: Rated voltage applied for 30 minutes with protective resistor (1K), then stored for 24-48 hours. |
| Endurance | Capacitance change: Within 20% of initial value; tan: Within 1.5 times of item 2 value; ESR: Within 1.5 times of item 2 value; Leakage current: Within item 2 value. | Temperature: 105 2; Duration: 2000 +48/-0h; Applied voltage: Rated voltage. |
| Damp heat, steady state | Capacitance change: Within 20% of initial value; tan: Within 1.5 times of item 2 value; ESR: Within 1.5 times of item 2 value. | Temperature: 602; Relative humidity: 90 ~ 95%; Duration: 1,000 +24/-0 hours. |
