| 1 | Capacitance | Test Frequency: 120Hz10Hz, Test Voltage: 0.5Vrms +1.0V.DC, Test Temperature: 202 | Tolerance capacitance 20%, Dissipation Factor 10%, Leakage Current 2310.0 uA, ESR 35 m |
| 2 | Dissipation Factor | Test Frequency: 120Hz10Hz, Test Voltage: 0.5Vrms +1.0V.DC, Test Temperature: 202 | 10% |
| 3 | ESR | Test Frequency: 100KHz10Hz, Test Voltage: 0.5Vrms +1.0V.DC, Test Temperature: 202 | 35 m |
| 4 | Leakage Current | Test Voltage: 35 V, Charging time: 2 min, Test Temperature: 202 | 0.2CV or 300A (whichever is greater) |
| 5 | Resistance to Soldering Heat | Preheating: 1202s, Solder bath temp: 2605, Immersion depth: 1.5~2.0mm, Immersion duration: 101s | No appearance defect, Capacitance change within 10%, DF smaller than specification, ESR smaller than specification, Leakage current smaller than specification |
| 6 | Solder Ability | Solder bath temp: 2452, Immersion depth: 1.5~2.0mm, Immersion duration: 20.5s | Solder alloy covers 95% of dipped lead's area |
| 7 | Damp Heat | Temperature: 602, Relative humidity: 90-95%, Duration: 2408 hours | No electrical/mechanical damage, Capacitance change within 20%, DF < 1.5x specification, Leakage current < specification |
| 8 | Surge Voltage | Test Temp: 15~35 , Cycle: 1000 times (30s on, 330s off) | CAP change within 10%, DF specification, Leakage current specification, Appearance: No visible damage |
| 9 | Vibration | Frequency range: 10-55 Hz, Amplitude: 0.75 mm, Total duration: 32h (X-Y-Z directions) | Appearance: No visible damage or electrolyte leakage, CAP change within 5% |
| 10 | Terminal Strength | Tensile load as per diameter, Bending load as per diameter | No electrical or mechanical damage |
| 11 | Load Life | Test Temp: 105 2, Rated Voltage: 35 V, Test Time: 2000 (+72 -0) hours (after 16h at room temp) | No appearance defect, Capacitance change within 20%, DF < 2x specification, Leakage current < specification |
| 12 | Shelf Life | Test Temp: 105 2, Test Time: 1000 (+72 -0) hours (after 16h at room temp) | |
| 13 | Maximum Applicable Ripple Current | At 100KHz or 120Hz, 105 2 | Peak voltage not to exceed rated DC voltage |
| 14 | Low Temperature Test | Min operating temp for 722 hours | CAP change within 10%, DF specification, Leakage current specification, ESR specification |
| 15 | Rapid Change of Temperature | Cycles: 5 (Min temp 30min, Room temp <3min, Max temp 30min, Room temp <3min) | CAP change within 20%, DF specification, Leakage current specification |
| 16 | Flow Soldering Test | Preheating: 120 <120s (1 time), Soldering: 260 10s (2 times) | Capacitance change within 10%, DF, LC, ESR initial specified value |
