Power Inductor COILMX MS0630-5R6M Designed for Performance in Electronic and Battery Powered Devices

MS0630 Power Inductor

The MS0630 is a low-profile, high-current power inductor designed for a variety of electronic applications. It is ideal for battery-powered devices, DC/DC converters in distributed power systems, and DC/DC converters for field-programmable gate arrays (FPGAs). The MS0630 series offers excellent performance with a focus on reliability and efficiency.

Product Attributes

• Brand: MOTTOTECHNOLOGY
• Series: MS0630
• Origin: SHENZHEN MOTTOTECHNOLOGY Co.,Ltd
• Website: www.coilmx.com
• Email: sales@mottotech.com

Technical Specifications

Note: All test data is referenced to 25C ambient. Irms: DC current (A) that will cause an approximate T of 40C. Isat: DC current (A) that will cause L0 to drop approximately 30%. Operate between temperature range -55C to +125C. The part temperature (ambient + temp rise) should not exceed 125C under worst-case operating conditions. The rated current as listed is either the saturation current or the heating current depending on which value is lower.

Important Notes for Usage

• Storage time within 6 months. Storage conditions: temperature 5-40C, humidity below 10-75% RH.
• Terminal electrode solderability may degrade after the storage period.
• Do not use or store in a corrosive gas environment (salt, acid, alkali, etc.).
• Preheating is essential before soldering.
• The temperature difference between preheating temperature, soldering temperature, and chip temperature should be within 150C.
• Post-installation soldering corrections should be within the conditions specified in the procurement specification.
• Overheating may cause short circuits, performance degradation, or reduced lifespan.
• When assembling the printed circuit board with the chip into the device, be careful not to apply residual stress to the chip due to overall deformation of the printed circuit or local deformation of fastening parts.
• Devices generate heat (temperature rise) when energized, so sufficient margin should be left in thermal design.
• For magnetically shielded types, pay attention to coil placement during substrate design.
• Electromagnetic interference may cause malfunction.
• Use an anti-static wrist strap as static electricity from the human body can be transmitted to the ground line.
• Do not place the product near magnets or magnetic objects.
• Use within the range specified in the procurement specification.

Product Characteristic Curves

Refer to the product documentation for characteristic curves including L and I curve, T and I curve, and Reflow curve.

Disclaimer

This product catalog describes products for general standard use in general electronic equipment. For applications requiring high safety and reliability, or where failure, malfunction, or poor operation could lead to death, injury, or property damage, or have significant social impact (referred to as 'Specific Applications'), MOTTOTECHNOLOGY does not guarantee applicability, performance, quality, or reliability. Customers intending to use products outside the scope, conditions, or in Specific Applications described in this catalog must consult with MOTTOTECHNOLOGY's relevant departments beforehand. MOTTOTECHNOLOGY will negotiate alternative usage with the customer. For devices designed using products in this catalog, ensure protective circuits and devices, as well as backup circuits, are in place according to the device's intended use and operating conditions.

Power Inductor COILMX MS0630-5R6M Designed for Performance in Electronic and Battery Powered Devices Images