| General Information | Usage environment temperature | -20+70 | |
| General Information | Storage environment temperature | -40+70 | |
| General Information | Test condition | Temperature: 5~35, Humidity: 45~85%HR | |
| General Information | Soldering heat-resistance (Manual) | Max. 3505 at 3 sec | |
| General Information | Soldering heat-resistance (Auto) | Max. 2605 at 3 Sec. | Preheating temperature of board surface: 100 max. at within 1 minutes. |
| General Information | Soldering heat-resistance (Note) | Not applicable to reflow soldering. | |
| Construction | Appearance | Every part should be finished, not exist rust flaw, crack, and bad plating. | |
| Construction | Measurements | Under conditions prescribed by design drawing. | |
| Mechanical Characteristics | Potentiometer Total rotational angle | 30010 | |
| Mechanical Characteristics | Potentiometer Rotational torque | 20~120gf.cm | |
| Mechanical Characteristics | Potentiometer Detent quantity | 0, 1 | Applies when detent quantity is not "0". |
| Mechanical Characteristics | Potentiometer Detent torque | 50~250gf.cm | |
| Mechanical Characteristics | Potentiometer Rotational stopper strength | 3Kgf.cm | |
| Mechanical Characteristics | Shaft Pull-Push Strength | 8Kgf.cm | |
| Mechanical Characteristics | Nut tightening strength | 8Kgf.cm | |
| Mechanical Characteristics | Shaft wobble | < 0.5*shaft long L size/20mm | Applied 250gf on the tip of the single shaft. |
| Electrical Characteristics (Potentiometer) | Total resistance | 10 K10% | R1, R2 |
| Electrical Characteristics (Potentiometer) | End resistance (Terminals 1-2, 2-3) | 10 (for R10K) | 20 (for 10KR250K); 0.1% R (for R250K) |
| Electrical Characteristics (Potentiometer) | Resistance taper | A, B, C | |
| Electrical Characteristics (Potentiometer) | Ratings power | 0.05W (B Taper) | 0.025W (Other taper) |
| Electrical Characteristics (Potentiometer) | Maximum operating voltage | 10V DC or 50V AC (B Taper) | 5V DC or 25V AC (Other taper) |
| Electrical Characteristics (Potentiometer) | Slider noise | <100mV | |
| Electrical Characteristics (Potentiometer) | Insulation resistance | >100M (at 250V DC) | |
| Electrical Characteristics (Potentiometer) | Voltage proof | 300V AC for 1 minute | |
| Electrical Characteristics (Potentiometer) | Rotational life | 10,000 cycles, 30,000 cycles | Permissible resistance change 15% max. under no load at 600 cycles/hour. |
| Switch Characteristics | Apply/Not Apply | Apply | |
| Switch Characteristics | Switch type | Push type | |
| Switch Characteristics | Switch configuration, Contact point | Single Pole Single Throw (S.P.S.T) | |
| Switch Characteristics | Switch working angle | DC 12V, 0.5A | |
| Switch Characteristics | Switch push travel | 0.5+0.3/-0.3mm | |
| Switch Characteristics | Switch push pressure | 600200gf | |
| Switch Characteristics | Switch contact resistance | 50m | Afterlife cycle: 200m |
| Switch Characteristics | Switch operating life | 10,000 cycles | Under no load at 600 pushes/hour. Afterlife cycle: Withstanding voltage AC100V for 1 min (no insulation breakdown), meets push pressure spec, no damage to appearance/structure. |
