| 1 General Information | Applicable Models | R095, R096, R097, R098, R09J, R09P, R09B Series |
| Usage Environment Temperature | -10+70 or -20+70 |
| Storage Environment Temperature | -40+85 |
| Test Condition | Temperature: 5~35, Humidity: 45~85%HR |
| Soldering Heat-Resistance | Hand soldering: Max 3505 at 3 sec; Auto soldering: Max 2605 at 3 sec. Preheating of board surface: Max 100 within 1 minute. |
| 2 Construction | Appearance | Parts should be complete, without rust, cracks, or bad plating. |
| Dimensions | Under conditions prescribed by design drawing. |
| 3 Mechanical Characteristics | Total Rotational Angle | 30010 |
| Rotational Torque | 10~200gf.cm (Rotational velocity: 60/1 Sec.) |
| Detent Torque | 80~250gf.cm |
| Detent Quantity | 0, 1, 21, 41 |
| Rotational Stopper Strength | 3Kgf.cm, 8Kgf.cm, 4Kgf.cm, 5Kgf.cm |
| Pull-Push Strength of Shaft | 8Kgf, 10Kgf |
| Nut Tightening Strength | 10Kgf.cm |
| Shaft Wobble | Radial deviation < 0.7*shaft long L size/20mm at 250gf on shaft tip. |
| 4 Electrical Characteristics | Total Resistance | 10 K20% or 10 K10% |
| Resistance Taper | A, B, C |
| End Resistance (Terminal 1-2, 2-3) | 10 for R10K; 20 for 10KR250K; 0.1%R for R250K. |
| Ratings Power | B Taper: 0.05W; Other taper: 0.025W. |
| Maximum Operating Voltage | B Taper: 20V DC or 50V AC; Other taper: 12V DC or 25V AC. |
| Slider Noise | <100mV |
| Gang Error (Dual-Unit only) | 4dB (-40dB~0dB) or 3dB (-40dB~0dB) |
| Insulation Resistance | >100M at 250V DC |
| Voltage Proof | 300V AC for 1 minute |
| Rotational Life | 10,000 cycles, 15,000 cycles, or 30,000 cycles. (Max resistance change 15% under no load at 600 cycles/hour). |
| 5 Switch Characteristics | Applicability | Apply or No apply |
| Switch Type | Rotary type or Push-Push type |
| Switch Circuit | Single Pole Single Throw (S.P.S.T) |
| Switch Ratings Power | Rotary switch: 12V DC 1A; Push-Push switch: 12V DC 0.5A. |
| Switch Contact Resistance | 100 m max. initially; 1 max. after 10,000 cycles. |
| Switch Working Angle or Track | Rotary switch: 5010; Push-Push switch track: 0.5mm or 1.5mm (refer to drawing). |
| Switch Working Torque | Rotary switch: 800gf.cm max.; Push-Push switch: 700300gf. |
| Switch Life | 10,000 cycles |
| 6 Waterproof Characteristics | Waterproof Standard | No apply or Grade -7. (For Grade -7: Potentiometer shaft and bush in 1M deep water, other sealed components exposed to atmosphere for 30 min, no water ingress.) |
