| 1. General Information | Applying range | Home appliances | |
| Operating temperature range | -30+70 | |
| Storage temperature range | -40+85 | |
| Test condition | Temperature 535, Moisture: 4585%RH | As our standard condition |
| 2. Appearance and Dimensions | Appearance | No harmful rust, cracks, scratches and poor under functioning | |
| Dimensions | Refer to attached drawing | |
| 3. Mechanical Characteristics | Shaft material | PA9T | |
| Detent torque | 80~250 gf.cm | (before reflow test and cycle test) |
| Number of detent | 10 detents | |
| Total rotational angle | 360 | |
| Terminal strength | Shall be free from terminal looseness damage and breakage of terminal soldering position. terminals may be bent after test. But electrical performance requirements specified in item 4 shall be satisfied. | A static load of 4.9N(0.5kgf) shall be applied to the tip of terminal for 10S in a desired direction. The test shall be done once per terminal. |
| 4. Electrical Characteristics | Total resistance | 10K20% | |
| Power rating | 0.05W | |
| Maximum operating voltage | DC 5V | |
| Insulation resistance | 100MMIN | DC100V 1min5S. Applied position: Between all terminals and ground(frame) |
| Voltage proof | No subversion on insulation resistance | AC250V 1minute. Applied position: Between all terminals and ground(frame) |
| 5. Durability | Rotational life | Total resistance10K20%. Detent torque 50gf.cm min. | 25,000 steps (without load) |
| Cold resistance | Specification in clause 3, 4 shall be satisfied. | -40 96 hours (left without loading) |
| Heat resistance | Specification in clause 3, 4 shall be satisfied. | 85 96 hours (left without loading) |
| Moisture resistance | Specification in clause 3, 4 shall be satisfied. | 40 90-95%RH 96 hours (left without loading) |
| 6. Soldering Conditions | Soldering Heat Resistance | Hand Soldering: 3505/ 3S Max. | |
| | Meet reflow J-STD-080D standard | |
| Solderability | NO abnormalities shall be observed in appearance and operation. The electrical performance requirements specified in item 4 shall be satisfied. A new uniform coating of solder shall cover a minimum of 75% of the surface being immersed. | Solder temperature: 2355. Solder dipping time: 3.50.5S |
