| General Information | Applicable Models | R084 Encoder & Potentiometer compound Serial |
| Usage Environment Temperature | -20+70 or -30+70 |
| Storage Environment Temperature | -40+70 |
| Test Condition | Temperature: 5~35, Moisture: 45~85%HR |
| Soldering Heat-Resistance | Manual: Max 3505 at 3 sec. Auto: Max 2605 at 3 Sec. (Preheating: 100 max. within 1 min). Not applicable for reflow soldering. |
| Mechanical Characteristics | Encoder Total Rotational Angle | 360 |
| Encoder Rotational Torque | 50~300gf.cm (Rotational velocity: 60/1 Sec.) |
| Encoder Number of Detents | 20 Detents |
| Encoder Change-Over Angle | 183 |
| Potentiometer Total Rotational Angle | 30010 |
| Potentiometer Rotational Torque | 20~120gf.cm |
| Potentiometer Rotational Stopper Strength | 3Kgf.cm |
| Encoder Electrical Characteristics | Voltage Rating | DC 5V |
| Current Rating | 1mA |
| Voltage Proof | AC 300V for 1 Minute (Between terminal case, Between terminal shaft) |
| Maximum Operating Current | 2.5mA |
| Contact Resistance | 10 |
| Insulation Resistance | DC 250V, 100M (Between terminal case, Between terminal shaft) |
| Potentiometer Electrical Characteristics | Total Resistance | 10 K10% or K20% |
| End Resistance (Terminal: 1-2, 2-3) | R10K: 10; 10KR250K: 20; R250K: 0.1% R |
| Resistance Taper | A, B, or C |
| Ratings Power | B Taper: 0.05W, Other taper: 0.025W |
| Maximum Operating Voltage | B Taper: 10V DC or 50V AC, Other taper: 5V DC or 25V AC |
| Slider Noise | 100mV |
| Insulation Resistance | 250V DC, 100M |
| Switch Characteristics | Applicability | Apply / No Apply |
| Switch Type | Rotary Type |
| Switch Circuit | Single Pole Single Throw (S.P.S.T) |
| Switch Ratings Power | 12V DC 1A |
| Rotational Life | Encoder | 10,000 cycles or 30,000 cycles |
| Potentiometer | 10,000 cycles or 30,000 cycles (Permissible resistance change 15% max.) |
| Waterproof Standard | Grade -7 Of Waterproof standard (No Apply option available) |
