| Maximum permissible ripple current | Temperature:1052, Ripple frequency:100KHz | Refer to table |
| Surge | Temperature:1052, "ON" position : 30 seconds, "OFF" position :5 minutes 30 seconds, Duration 1000 cycles | 1.No electrical or mechanical damage. 2.Capacitance change within 15%. 3.D.F.smaller than specification volue. 4.Leakage current smaller than specification volue. |
| Temperature Cycle | One Cycle: Rated high category temperature3 (303 min), 25 (3MAX min), Rated low category temperature3 (303 min), 25 (3MAX min). Total number of cycles: 5 | 1.No appearance defect. 2.Capacitance change within 5% 3.D.F.smaller than specification value. 4.Leakage current smaller than specification value. |
| Resistance to Soldering Heat | Warm up time :1202 seconds to reach 1202, Solder bath temperature: 2605, Immersion depth: 1.5 to 2.0mm, Immersion duration: 101 seconds | 1.No appearance defect. 2.Capacitance change within 5% 3.D.F.smaller than specification value. 4.Leakage current smaller than specification value. |
| Solder Ability | Solder bath temperature: 2355, Immersion depth: 1.5 to 2.0mm, Immersion duration: 101 seconds | A minimum of 95% the immersed surface is to be coated with the new solder |
| Low Temperature Characteristics (Max.Impedance Ratio) | Working Voltage (v): 6.3, 10, 16, 25, 35, 50, 63, 100 | Impedance Z-40/+20: 8, 6, 4, 3, 3, 3, 3, 3 |
| High Humidity Storage | Temperature:402, Relative humidity :90 to 95%, Duration 2408 hours | 1.No electrical or mechanical damage. 2.Capacitance change within 15%. 3.D.F.smaller than specification volue. 4.Leakage current smaller than specification volue. |
| Vent | Conduct under normal lighting for lab work | There shall be no explosion,flash,flame,spark or fire from the capacitor during or after the test,nor shall there be expulsion of any metal from the casing |
| Terminal strength: Tensile test intensity/winding intensity | Tensile test intensity: 0.5d0.8 (10N, 101sec), 0.8d1.25 (20N, 101sec). Winding intensity: 0.5d0.8 (5N, 0.51kg), 0.8d1.25 (10N, 1.02kg) | 1.No electrical or mechanical damage 2.No appearance damage |
| Vibration | Frequency range : 10 Hz to 55 Hz, Amplitude :1.5 mm, Cycle definition:10Hz to 55 Hz and back to 10Hz, Cycle duration :1 minute, Duration :2 hours per direction (3directions) | 1.No electrical or mechanical damage 2.No appearance damage |
| Endurance | Capacitors are placed in an oven and applied voltage for 3000 hours at 105.After being restored to 25, capacitors shall meet the specifications. | 1.Capacitance change within 20% of the initial value. 2.D.F.change within 200% of the specified value. 3.Leakage current smaller than specification value. |
| Shelf Life | Capacitors are placed in an oven for 1000 hours at 105 without applying rated working voltage.After being restored to 25, capacitors shall meet the specifications | 1.Capacitance change within 20% of the initial value. 2.D.F.change within 200% of the specified value. 3.Leakage current within 200% of the specification value. |
